Audi Q7 e-tron quattro 4M - Page 29

29
As has been the case since the launch of the AudiA5(type8T), the
torsion damper transmission plate must be disconnected from the
engine flywheel via the service port in order to remove the 0D7
gearbox. See SSP 392.
649_065
649_066
Hybrid module
page 30
Torsion damper
transmission plate
Torsion damper
Torsion damper
transmission plate
Service port/
screw coupling of transmission plate
3.0l V6 TDI engine
Side shaft protection tube
When the hybrid module is separated from 0D7 gearbox, the side shaft protection tube
is hanging loosely in the rear gasket ring and can drop down.
Power terminals of
the e-machine
UVW
Front gasket ring
of the protection tube
Front axle drive
Flywheel
Starter generator
C29,
page 19
Note
For removal and installation of the basic gearbox and the hybrid module as well as all other components, the instructions
given in the workshop manual must be followed.
ProCarManuals.com
< Back
Forward >
Ξ Contents