Audi RS 3 LMS SEQ - Page 27

27
#7: Transponder
This auxiliary connector is placed behind the right front headlight. All Audi RS 3 LMS cars are provided
without transponder.
Transponder
Matching connector
357 972 762
Pin-out
Terminal
1
12v
FS 2,8 x 0,8
2
GND
FS 2,8 x 0,8
#8: Additional headlights
This auxiliary connector is placed behind the left front headlight, under the engine ECU. All Audi RS 3 LMS
cars are provided without additional headlights but this connector is ready for a plug and play solution that
allows the driver to turn additional headlights from the steering wheel.
Additional headlights
Matching connector
AMP Super-seal 3-
way 282105-1
Pin-out
Terminal
1
12v
AMP 183024-1
2
GND
AMP 183024-1
3
signal
AMP 183024-1
Following two recommended solutions to install the headlights electrically:
Option 1:
Notes:
 Total maximum current 7 A.
 Mandatory to install a maximum 100 mA coil current relay. TE 3-1414773-5 recommended.
 Mandatory to install a freewheel diode on relay’s coil.
 When using the DRV signal pin, the headlights will switch on together with the standard high beam
when pushing the steering wheel dedicated button.
Option 2:
Notes:
 Total maximum current 7 A.
7
8