57
Maintenance and repair operations, removal of components
Many air conditioning components can be removed without
removing the instrument panel.
The following components can be replaced with the instru-
ment panel installed:
• Heat exchanger.
• A/C servomotors.
• Fresh Air Blower V2.
• Instrument Panel Temperature Sensor G56.
In most cases, the components can be accessed after
taking out the driver side instrument panel cover or knee
airbag or after removing the glove compartment.
630_068
630_069
Dust and pollen lter
The procedure for removing and installing the dust and
pollen lter is the same as for the AudiA3. The lter
service cover is located inside the glove compartment.
If the dust and pollen lter is heavily clogged, falling dirt
particles can damage Fresh Air Blower V2.
To avoid this, it is recommended that cover plate T10532
be positioned below the dust and pollen lter before
removing the lter.
The following special tools are required for removing the
dust and pollen lter:
• Hook T40207 (this is only needed if there is no hook
on the service cover).
• Vacuum cleaner.
• Cover plate T10532.
Service cover Pollen lter Fresh Air Blower
V2
Front Air Distribution Door Motor
V426
Left Temperature Control
Door Motor
V158
To Next Page
Loading...
