If you need to exit the AuNet program it will still run in the systray until you
manually quit by right clicking on the icon in the system tray and select quit.
Setting up the console with DHCP (for use with routers)
If you have more than one device connected to your DAW computer, you will most
likely be using a network router to talk to all of these devices. If you have
connected ASP8024-DLC to your DAW computer via a network router, you will
need to use DHCP to enable automatic configuration of IP address, providing fast
and smarter networking.
Ensure that you enable ‘obtain IP addresses automatically’ in:
Network Connections > Local Area Connections > Internet Protocol TCP/IP
Properties (you should already know how to do this if you are running an existing
network).
You will most likely be running DHCP with automatic IP hand out. Ensure that the
console is set to use DHCP on the second page of the setup menu, once set reboot
the console and follow the same AuNet connection procedure as outlined
previously once the console is detected.
To Next Page
Loading...
Need help?
General