Audient EVO 4 Quick Guide

Welcome to your new EVO 4 Audio Interface. Please
read this quick guide to help get you started.
Connect
To connect your EVO 4 to your computer,
simply plug in the USB cable provided. Once
successfully connected, EVO 4’s volume
wheel LEDs will illuminate and perform a
short animation followed by the Volume
button illuminating.
01
Install Drivers
In order to start using your EVO 4 you will need
to download and install the latest drivers, which
can be found at evo.audio/evo4/downloads.
Once the drivers are installed, you may be
prompted to update the units rmware. A full
installation guide can be found on our website.
02
The Features
1. Smartgain Mode
2. Inputs 1 + 2
3. Phantom Power
4. Volume knob
5. Monitor Mix
6. Output volume
03
2
3
4
6
5
1

Audient EVO 4 Specifications

General

Type	Audio Interface
Number of Preamps	2
Bit Depth	24-bit
Bus Powered	Yes
Direct Monitoring	Yes
Loopback	Yes
Phantom Power	48V
Sample Rate	96 kHz
Inputs	2 x XLR/TRS Combo
Outputs	2 x TRS
Simultaneous I/O	4 in / 4 out
USB	USB-C
Driver	Class Compliant