What to do if the Audio Analogue Amplifier remote controller doesn’t work?
If the remote controller for your Audio Analogue Amplifier isn’t working, first, ensure that the batteries are correctly placed and not worn out; replace them if necessary (2 ‘AAA’ batteries). If that doesn't work, try getting closer to the unit or reducing the angle at which you are standing from the front panel.
Why is there no sound and only one LED is on on my Audio Analogue Puccini Settanta Amplifier?
If you are experiencing no sound and only one LED is on for your Audio Analogue Amplifier, try the following: * Turn the volume knob to the right to increase the volume. * Check the signal cords and their connections between the amplifier and the audio sources. * Verify that the source is on, active, and correctly selected using the input selector. * Check the power cords and their connection between the amplifier and the speakers.
How to fix recording issues with Audio Analogue Amplifier?
If you're unable to record with your Audio Analogue Amplifier, ensure that you've selected the correct source using the recording selector.
How to troubleshoot no LED and no sound on Audio Analogue Amplifier?
If there is no LED light and no sound coming from your Audio Analogue Amplifier, ensure that the power cord is correctly plugged into the wall outlet. Also, after unplugging the power cord, check the fuses in the fuse panel above the IEC inlet and replace them with new ones of the same type if they are burned out.
What to do if Audio Analogue Amplifier input LEDs and volume LEDs are mismatched?
If the selected input LEDs are on but the volume control LEDs are off (or vice versa) on your Audio Analogue Amplifier, this could indicate a faulty or incorrectly plugged front panel. Contact your Audio Analogue retailer for a connections check and front panel substitution.
General| Type | Integrated Amplifier |
|---|---|
| Total Harmonic Distortion | < 0.1% |
| Signal-to-Noise Ratio | > 100 dB |
| Inputs | 4 x RCA, 1 x XLR |
| Power Output | 70 W per channel (8 Ohm) |
| Input Impedance | 47 kOhms |
| Outputs | 1 x Pre-out |
To Next Page
