7
Features
Features of ATDM-0604
• 4 Mic inputs, 2 Mic/Line inputs, 1 unbalanced stereo input
• 2 balanced outputs, 1 unbalanced stereo output
• USB audio I/O (1 stereo input and 1 stereo output)
• Built-in SmartMixer that allows for a selection between gain sharing and gate modes
• Equipped with an echo canceler and a noise canceler that can be used simultaneously (with up to 6 Mic inputs)
• Includes a 4-band EQ for each input channel, and a 12-band EQ for each output channel
• Equipped with a compressor, a limiter, and a 8-band feedback suppressor for each output channel
• Audio input/output settings can be configured on the front panel, whereas the advanced settings can be configured on a computer using Web Remote.
• Allows for external control with IP Remote Protocol
• Supports ES954 Hanging Microphone Array and can be set from a Windows-based PC, Mac, iOS or Android device through the Web Remote
• Equipped with a ducking function
About Audio-Technica LINK
Up to six ATDM-0604 model mixers can be daisy-chained so that, as a whole system, it can handle audio inputs from 24 Mic channels, 12 Mic/Line
channels, and 6 unbalanced stereo channels.
The proprietary Audio-Technica LINK functionality enables the transmission of low-latency, high-speed audio bus signals between devices, making
it possible to steadily control and transmit uncompressed audio signals. Furthermore, the model offers excellent workability as it conforms to the
Ethernet standards and can be connected to generic LAN cables (shielded cables of Cat5e or above with the conductor diameter size of 24 AWG or
larger are recommended).
System installation
Installing on a rack
The product can be installed using the supplied rack-mount.
• When installing the product on a rack, make sure that the temperature inside the rack does not reach or exceed 40°C. Higher temperatures may
negatively affect the internal parts of the product, causing the product to malfunction.
• Ensure at least a 10-centimeter space between the product and other devices or the top, side, and back faces of the rack.
• The required rack specifications are as follows.
– EIA-standard 19-inch rack
– 1U-size attachable rack
– Rack with a shelf on which the product is placed or a guide rail that supports the product
• The rack mounts are affixed to the product with the following screws. Check the following when using screws other than those supplied.
– S-tight (tapping screw), nominal diameter 4 × 6 mm
To Next Page
Loading...
Need help?
General
