7
Connecting via Bluetooth wireless technology
Pairing a Bluetooth device
To connect the product to a Bluetooth device, the product needs to pair (register) with the device.
• Read the user manual for the Bluetooth device.
• Place the device within 1 m (3.3') of the product to perform pairing correctly.
• To confirm the progress of the pairing process, wear the product while performing this procedure and listen for the
confirmation tone.
1. Starting with the product turned off, slide the power switch to the “ON” position.
• The indicator lamp will light in white, and then flash.
2. Use your Bluetooth device to begin the pairing process and search for the product.
When your Bluetooth device finds the product, “ATH-M50xBT” will be displayed on the device.
• For information about using your Bluetooth device, refer to the device’s user manual.
• This product may be displayed as ATH-M50xBT, BLE_ATH-M50xBT or both. If both are displayed, select ATH-
M50xBT. If either one is displayed, select that display.
3. Select “M50xBT” to pair the product and your Bluetooth device.
• Some devices may ask for a passkey. In this case, enter “0000”. The passkey
may also be called a passcode, PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
About pairing
To connect the product to a Bluetooth device, the product needs to pair (register) with the device. Once they are paired,
you do not need to pair them again.
However, you will need to pair again in the following cases:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• If nine or more devices are paired.
(This product can save the pairing information of up to eight devices. When you pair with a new device after pairing
with 8 devices, pairing information for the device with the oldest connection date will be overwritten by the informa-
tion for the new device.)
• When switching Bluetooth devices, pairing may not be possible due
to inability to release the connection with the Bluetooth device con-
nected immediately before. In that case, touch the volume button (+/-)
and the control button for 8 seconds as shown in the figure. The prod-
uct will switch to the "device searching" state and you will be able to
pair with the Bluetooth device you want to connect.
100%12:00
Bluetooth ON
ATH-M50xBT
To Next Page
Loading...
Need help?
General
Weight and Dimensions
