6. Select the OAMP interface ('Application Type' with OAMP + Media + Control), click Edit, and then in
the dialog box, modify the device's OAMP interface.
7. Click Apply to submit your changes; your connection with the device becomes unavailable at the
default IP address (due to the new IP address).
8. Change the IP settings of your computer to correspond with the new OAMP IP addresses and subnet of
the device.
9. Access the device again, but at its' new IP address, and then on the Web interface's toolbar, click the
Save button; the new IP address is now saved to the device's flash memory.
10. Re-cable the device to the required network. You can now access the device's management interfaces
remotely, using the new IP address.
To Next Page
Loading...
