Need help?Do you have a question about the AudioCodes Mediant 500 and is the answer not in the manual?
General| Humidity | 10% to 90% non-condensing |
|---|---|
| Protocols | SIP, H.323 |
| Type | VoIP Gateway |
| Interfaces | E1/T1 |
| VoIP Media Processing | G.711, G.723.1, G.726, G.729 |
| Management | Web-based, SNMP, CLI |
| Ports | E1/T1, FXO, FXS, BRI |
| Voice Codecs | G.711, G.723.1, G.726, G.729 |
| Echo Cancellation | G.168 |
| DTMF | RFC 2833, SIP INFO, In-band |
| Fax Support | T.38 |
| Operating Temperature | 0°C to 40°C |
Details on gateway vendor, models, software version, and protocols.
Instructions to download firmware, configuration, and tones files from Support Centre.
Steps to connect the PC to the device's Ethernet port and power it on.
Visual guides for Mediant 500 front and rear panels for connection.
Navigating the web interface to start the software upgrade process.
Steps to load .cmp, .ini, and .cpt files and finish the upgrade.
Change default login passwords and secure user access to the device.
Configure IP address, subnet mask, gateway, DNS, and NAT rules.
Configure SIP parameters, PSTN interface, coders, and call routing.
Check SIP trunk registration status and save the device configuration.
Connects the device to the DMZ network after configuration.
Establish serial communication and log in to the device CLI.
Commands for enabling SIP call debugging and syslog messages.
To Next Page
