BroadSoft SIP Trunk
Quick Guide 32 Document #: LTRT-14020
5.6 Miscellaneous Configuration
This section describes miscellaneous Mediant gateway configuration.
5.6.1 Configure Supplementary Services
This step describes how to configure Hold Format.
To configure Hold Format:
1. Open the Gateway Supplementary Services Settings page (Setup menu > Signaling
& Media tab > Gateway folder > DTMF & Supplementary > Supplementary
Services Settings).
2. From the 'Enable Hold to ISDN' drop-down list, select Enable.
3. From the 'Hold Format' drop-down list, select Send Only.
Figure 5-20: Configuring Hold Format
4. Click Apply.
5.6.2 Configure Gateway General Settings
This step describes how to configure the Mediant Gateway to enable T.38 Fax Signaling
Method and to play ring-back tone to PRI trunk.
To configure Gateway General Settings:
1. Open the Gateway General Settings page (Setup menu > Signaling & Media tab >
Gateway folder > Gateway General Settings).
2. From the 'Fax Signaling Method' drop-down list, select T.38 Relay.
Figure 5-21: Configuring Fax Signaling Method
To Next Page
Loading...
