AudioCodes Mediant 4000 SBC - Figure 4-8: Fastening Rear-Mounting Flange to Rear-Mounting Bracket (60 CM); Figure 4-9: Fastening Rear-Mounting Flange to Rear-Mounting Bracket (80 CM); Figure 4-10: Front-Mounting Brackets Flush and Aligned with Front-Rack Posts (60 CM)

Hardware Installation Manual 26 Document #: LTRT-41511
Mediant 4000 SBC
6. Hold the chassis in position while the second person secures the rear-mounting flanges
to the rear-mounting brackets. Insert the supplied screws (6-32 x 5/16 inch) from the
inside of the rack, through the flange's grid and into the screw hole on the rear-mounting
bracket. Finger-tighten the screws but make sure that the screws are NOT fully
tightened and that the flange can freely move on the slide rails of the rear-mounting
bracket.
Figure 4-8: Fastening Rear-Mounting Flange to Rear-Mounting Bracket (60 cm)
Figure 4-9: Fastening Rear-Mounting Flange to Rear-Mounting Bracket (80 cm)
7. Hold the chassis for support while the second person positions the chassis so that the
front-mounting brackets are flush against the front-rack posts and that the holes of the
front-mounting brackets align with the holes on the front-rack posts.
Figure 4-10: Front-Mounting Brackets Flush and Aligned with Front-Rack Posts (60 cm)