Changing VMware Host's Network Settings
The default IP address of the VMware ESXi host on whose virtual machine the ZPLS module is running is
192.168.0.10/24. Instead of using this default address, you can change it (and other network settings) to suit
your IP addressing scheme.
To change VMware host's networking address:
1. Connect the RJ-45 connector on one end of a straight-through Ethernet cable (not supplied) to the
device's Gigabit Ethernet port #1 (located on the rear panel), and then connect the other end of the
cable to your computer (or laptop).
2. Change your computer's IP address (e.g., 192.168.0.100/24) so that it's in the same subnet as the
default address of the VMware host.
To Next Page
Loading...
