AudioCodes MediaPack 114 - IP to Hunt Group Routing; Restricting Outbound Calls to 911; Automatic Dialing Configuration; FXO Port Auto-Dialing on Incoming Calls

RingCentral
®
Datasheet | AudioCodes Gateway Configuration Guide
• Navigate to VoIP / GW and IP to IP / Routing / IP to Hunt Group Routing and set up row 1 as shown. You can restrict outbound to FXO
to only allow 911 by replacing “*” in the Dest. Phone Prefix table to 911 or any variation of patterns you want to allow versus “*” for all
destinations, depending on your needs.
• Navigate to VoIP / GW and IP to IP / Analog Gateway / Automatic Dialing and set port 3 as show below. “CO_Line” is just a marker to
allow for automatic dialing to occur when the FXO port receives an incoming call.