Audiolab M-DAC + User Manual

7: The Menu
Page 8
The menu enables you to customize the unit and optimize the interface with other equipment in your system.
M-DAC+ has 14 different menu pages. Press the MENU key on the remote control to enter menu mode, and then press
or
to turn to different menu pages, press to enter any
menu page, press
or
again to select different settings, press again to confirm the chosen setting and exit the menu mode. Pressing the MODE knob on the front panel can
also enter the menu mode, rotating this knob turns through the menu pages; press the MODE knob again to enter any menu page and rotate the knob to change the setting, press the
MODE knob again to select a setting. No operation for 5 seconds will also exit menu mode automatically. The setting will not take effect if or the MODE knob is not pressed.
The Menu Tree
The chart shows the menu options. The default settings are at the top.
Digital Filter
Optimal Trandient XD
Digital Filter
Optimal Transient DD
Digital Filter
Sharp Rolloff
Digital Filter
Minimum Phase
Digital Filter
Optimal Spectrum
Digital Filter
Optimal Transient
DSD Bandwidth
Normal
DSD Bandwidth
50k
DSD Bandwidth
60k
DSD Bandwidth
70k
Track & Time
Show If Available
Track & Time
Do Not Show
Sampling Rate
Nominal Frequency
Sampling Rate
Actual Frequency
Jitter Rejection
Automatic
Jitter Rejection
Low Bandwidth
Jitter Rejection
Medium Bandwidth
Jitter Rejection
High Bandwidth
Default Input
Recall Last Input
Default Input
COAX1
Default Input
CPAX2
Default Input
OPT1
Default Input
PC USB
Default Input
USB A
Default Input
AES3
Trigger A Control
Enable
Trigger A Control
Disable
Trigger B Control
Enable
Trigger B Control
Disable
Trigger B Control
Follow Trigger A
Balance
0.0dBL R
Balance
3.5dB R
Balance
4.5dBL
Output Level
Adjustable
Output Level
0dBr (2.2 Vrms)
Output Level
+3dBr (3.1 Vrms)
Factory Reset
No
Factory Reset
Reset
Software Version
Ver:0.0013
Auto Standby
Never
Auto Standby
20 Minutes
Digital Filter
Slow Rolloff
Display Brightness
High
Display Brightness
Low
Display Brightness
Off

Audiolab M-DAC + Specifications

General

Analog Outputs	1x RCA, 1x XLR
Frequency Response	20Hz - 20kHz (+/- 0.2dB)
DAC Chip	ESS Sabre32 9018
Type	DAC
Digital Inputs	USB, Coaxial, Optical, AES/EBU
THD+N	<0.002%
Dynamic Range	>115dB
DSD Support	DSD64, DSD128
Digital Outputs	1 x Coaxial, 1 x Toslink Optical
Headphone Output	Yes
Sample Rates	Up to 384kHz
Output Impedance	10 Ohms