Need help?Do you have a question about the Audiopipe APMI-1500 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Power Output (Peak) | 3000W |
| Signal to Noise Ratio | >70dB |
| Input Sensitivity | 200mV - 6V |
| Low Pass Filter | 40Hz - 180Hz |
| Subsonic Filter | 10Hz - 50Hz |
| RMS Power at 1 Ohm | 1500W |
| Bass Boost | 0dB - 12dB |
| Phase Shift | 0 - 180 degrees |
Details on speaker terminals, +12V power, remote turn-on, and ground connections.
Covers RCA inputs, bridging inputs/outputs, and remote bass level control.
Explains gain, low-pass filter (LPF), subsonic filter, and bass boost controls.
Describes the protection and power indicator LEDs for amplifier status.
Specifies power, ground wire gauge, and fuse ratings for different amplifier models.
Recommendations for secure mounting, heat dissipation, and proper cable management.
Important considerations for linking two amplifiers for increased power output.
Diagrams showing how to connect one speaker for APMI-600/1300/1500 and APMI-2000.
Wiring configurations for connecting two speakers to APMI-600/1300/1500 models.
Diagrams for linking two amplifiers for a single channel with APMI-600/1300/1500 and APMI-2000.
Solutions for when the amplifier's power indicator does not illuminate.
Troubleshooting steps for when the amplifier is on but produces no audio output.
Identifies potential causes for diminished bass performance.
Addresses issues where the amplifier repeatedly turns on and off.
Detailed technical specifications for the APMI-600 and APMI-1300 amplifier models.
Detailed technical specifications for the APMI-1500 and APMI-2000 amplifier models.
To Next Page
