Need help?Do you have a question about the Audiopipe APMI-600 and is the answer not in the manual?
General| Channels | 1 |
|---|---|
| Signal to Noise Ratio | >90dB |
| THD | < 0.1% |
| Input Sensitivity | 200mV - 6V |
| Fuse Rating | 40A |
| Subsonic Filter | 15Hz-50Hz |
| Bass Boost | 0-12dB |
| RMS Power @ 4 Ohms | 300 Watts |
Connect speaker cables correctly, matching polarity, and use appropriate gauge wire to prevent amplifier damage.
Connect the positive battery terminal with a fuse installed near the battery for safety and proper operation.
Ensure a tight connection to a massive, conductive chassis ground point for optimal grounding.
Adjust gain to match source unit output; set to avoid distortion for clear, undistorted audio.
Details recommended power, ground wire gauge, and external fuse ratings for each amplifier model.
Solutions for when the amplifier's run indicator does not light up, checking fuses, cables, and voltage.
Troubleshooting steps for when the amplifier is on but produces no sound, checking volume, gain, and cables.
Guidance for amplifiers that switch on and off, focusing on ground, power, and remote connections.
To Next Page
