Need help?Do you have a question about the Audiopipe APSM-1300 and is the answer not in the manual?
Details on connecting speaker cables to terminals and the BATT+ power terminal with fuse.
Covers Gain, Remote Bass Level, RCA input, Low Pass Filter, Subsonic, and Bass Boost controls.
Information on Bridge In/Out connections and the Protect/Power indicator LEDs.
Diagram illustrating a single speaker mono setup for APSM-1300/APSM-1500 models.
Diagram showing a single speaker mono setup for the APSM-2000 model.
Diagram illustrating two speaker mono setup for APSM-1300/APSM-1500 models.
Diagram for linking two APSM-1300/APSM-1500 amplifiers for a single channel.
Power Output| RMS power at 4 Ohm | 400W |
|---|---|
| RMS power at 2 Ohm | 600W |
| RMS power at 1 Ohm | 1000W |
Audio Specifications| Input Level | 0.2 ~ 5V |
|---|---|
| Frequency Response | 8 ~ 180Hz |
| LPF | 40 ~ 180Hz |
| SUBSONIC Filter | 5 ~ 50Hz |
| Bass Boost Frequency | 55Hz |
| Bass Boost Level | 0 ~ 12dB |
| THD at 4 Ohm load 30% Rated Power | <0.15% |
| Signal Noise Ratio | 70dB |
Efficiency and Load| Best Efficiency | 85% |
|---|---|
| Minimum Load | 1 Ohm |
Protection and Build| Overheat Protect Temperature | 80˚C/176˚F |
|---|---|
| Components & PCB | SMT & Double Side Board |
| Transparent Isolation Connector | YES |
Power Output| RMS power at 4 Ohm | 600W |
|---|---|
| RMS power at 2 Ohm | 950W |
| RMS power at 1 Ohm | 1500W |
Audio Specifications| Input Level | 0.2 ~ 5V |
|---|---|
| Frequency Response | 8 ~ 180Hz |
| LPF | 40 ~ 180Hz |
| SUBSONIC Filter | 5 ~ 50Hz |
| Bass Boost Frequency | 30 ~ 80Hz |
| Bass Boost Level | 0 ~ 12dB |
| THD at 4 Ohm load 30% Rated Power | <0.2% |
| Signal Noise Ratio | 70dB |
Efficiency and Load| Best Efficiency | 85% |
|---|---|
| Minimum Load | 1 Ohm |
Protection and Build| Overheat Protect Temperature | 80˚C/176˚F |
|---|---|
| Components & PCB | SMT & Double Side Board |
| Transparent Isolation Connector | YES |
To Next Page
