To Next PageTo Next Page
Need help?Do you have a question about the AudioSource AMP One/A and is the answer not in the manual?
Front panel button switches the unit on/off; LED indicates power status with soft startup.
Knobs adjust incoming signal level, acting as volume controls; recommended to set high and use source volume.
Connect signal source line out jacks to the AMP One/A line in jacks.
Send original signal to additional amplifiers when using multiple units.
Switch from stereo to mono for high power (200W RMS); use right channel input and level control.
Connect speakers to five-way binding posts, observing red (+) and black (-) polarity.
Bridging switch off; connect stereo pre-amp line out to unit's line in jacks and speakers to terminals.
Bridging switch on; connect pre-amp line out to unit's right line in jack and connect mono speaker.
All safety and operating instructions should be read, retained, heeded, and followed before appliance use.
Avoid water, ensure proper ventilation, and keep away from heat sources for safe operation.
Connect to specified power sources, ensure proper grounding, and protect power cords from damage.
Clean as recommended, unplug during non-use, prevent object/liquid entry, and refer servicing to qualified personnel.
General| Brand | AudioSource |
|---|---|
| Model | AMP One/A |
| Category | Amplifier |
| Language | English |
