To Next PageTo Next Page
Need help?Do you have a question about the AudioSource Amp 300 and is the answer not in the manual?
Explains symbols used in the manual for user safety and warnings.
Lists critical guidelines for safe operation and installation of the amplifier.
Contact information for assistance with damaged or missing product parts.
Details the warranty period, coverage, and terms for product defects.
Controls the amplifier's on/off state and indicates power status via LEDs.
Allows selection of speaker set A or B for audio output.
Adjusts speaker output balance between left and right channels.
Provides fine adjustment for the amplifier's overall volume level.
Priority input for a secondary source with a minimum signal level.
Switches speaker level input routing to Line 1 or Line 2.
Connects sources with speaker-level outputs instead of line-level.
The primary line-level input and output for audio signals.
Sets a 3-15 second delay for Line 1 input to accommodate source switching.
Independent adjustment for maximum left and right channel output levels.
Allows remote turn-on/off of the amplifier via a 3.5mm trigger cable.
Selects power-on operation: Normal, Auto-On (signal sensing), or Trigger.
Output terminals for the right channel speaker connections.
Output terminals for the left channel speaker connections.
Connection for the power cord and integrated fuse protection.
Switch to select the correct AC mains voltage for operation.
Selects amplifier operation between Stereo and Bridged Mono modes.
Details connection points for speakers in stereo and bridged configurations.
Covers power cord connection, fuse protection, and voltage configuration.
Notes on using the amplifier with specific impedance loads and selectors.
Guide for connecting sources and speakers for stereo audio output.
Instructions for configuring the amplifier for single-channel mono operation.
Explains how to connect multiple audio sources with priority switching.
Detailed technical specifications for the AMP 200 model.
Detailed technical specifications for the AMP 300 model.
General| Amplifier Type | Stereo Power Amplifier |
|---|---|
| Power Output | 300W |
| Channels | 2 |
| Frequency Response | 20 Hz - 20 kHz |
| THD+N | < 0.1% |
| Signal to Noise Ratio | > 100 dB |
| Input Sensitivity | 1V |
| Gain | 32 dB |
| Signal-to-Noise Ratio | > 100 dB |
| RMS Power per Channel @ 4 Ohms | 150 watts |
| Bridged Mono Power @ 8 Ohms | 300W |
| Power Output @ 4 ohms | 150 watts |
| Output Impedance | 4 Ohms |
| Total Harmonic Distortion | <0.1% |
