AudioSource AMP 102 - User Manual

OWNER’S MANUAL
AMP102 / AMP110
Congratulations on your purchase of the AudioSource® AMP102/110.
Please take a few moments to read this entire manual, and be sure to
retain this document for future reference. Please read and observe all
safety instructions detailed on page 2.
NOTE: if any part of this product is damaged or missing, please call your
dealer or AudioSource® directly at 1.877.715.5439 or 503.914.4688.
Please read your warranty and retain your receipt and original carton for
possible future use.
For more information about AudioSource® electronics, speakers and
accessories please visit www.audiosource.net
AMP102 / AMP110
Home Audio Multi-Zone Power Amplifier
AudioSource®
13790 SW 72nd Ave.
Portland, OR 97223
503.914.4688
ww
w.audiosource.net
AMP102 / AMP110 Owner
’s Manual 8100.0360A
FEATURES:
Line 1 / Line 2 priority input switching
Line 2 auxiliary output
Speaker A/B switching
Front panel balance and volume controls
Front panel diagnostic LEDs
Signal sensing “Power On”
12VDC “Trigger On”
Rack-mount ready
AMP110 also features:
Triple-Darlington Power Amplifier Stages
Dual-differential error amplifiers

Summary

Important Safety Instructions

Limited Warranty

Front Panel Controls

Power

Controls the amplifier's on/off status; LEDs indicate power state and operational status.

Rear Panel Controls

Line 1 Input

A switching input that takes priority over Line 2 when a signal is present.

Line 2 Input;Output

The primary input and output for single-source audio connections.

Mode Select Switch

Selects between Stereo and Bridged mono operation modes.

Mains Power Inlet & Fuse Holder

Connects AC power and houses the protective fuse.

Mains Voltage Selector

AudioSource AMP 102 Specifications

General

Brand	AudioSource
Model	AMP 102
Category	Amplifier
Language	English