128-6814
6 of 8
7. Mounting the Antenna
The antenna should be placed on a relatively flat
surface whenever possible. To mount the antenna:
a. Plug the antenna into the SAT. (MAIN) connector
on the back of the cradle.
b. Place the antenna at the preferred location
inside or outside the home.
b. You can also place the antenna outside (on the
roof structure), provided it is clear of any
overhead obstructions.
NOTE: Because of the orbiting characteristics
of the Sirius Satellites, the strength of
the received signal may change over
time. In most cases however, the
signal should be available
continuously. If you experience a
loss of signal or audio, reposition the
antenna inside the home or outside
as necessary.
5. Installing the Shuttle on the Cradle
Place the Shuttle in the cradle so that the Shuttle
connectors are linedup; use the SAT and TERR
RF connectors as guides. Then gently press in on
the bottom of the Shuttle to engage the
connectors.
-6-
TERR. RF
CONNECTOR
16-PIN SYSTEM
CONNECTOR
SAT. (MAIN)
RF CONNECTOR
To Next Page
Loading...
Need help?
General
