Aspect Ratio
Press the WIDE button (28) on the remote control or WIDE button (22) on the monitor to adjust the aspect ratio as fol-
lows (only active with video source):
CINEMA
The entire screen is extended horizontally to the aspect ratio of 16 to 9. The extension ratio
is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical, leaving a blank
area on the right and left sides of the display.
STANDBY
Screen becomes black. Touch screen to resume.
Image Setting
Table 2 shows the video output mode for each playing source.
Parameter Adjustment Procedure
1. Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or press and hold the WIDE/PICTURE button (22) on the monitor.
2. Select Item to Set:
Use the up/down joystick buttons to select “BRIGHT” or “CONTRAST”.
3. Set Parameters:
Use the left/right joystick buttons to modify the settings.
4. Exit Picture Quality Setting Mode:
Press the PIC button on the remote control or the WIDE/ PICTURE button on the monitor
Parking Brake Inhibit
• When the “PRK SW” cable is connected to the brake switch, the display on the TFT monitor will display video only
when the vehicle is applied.
• Parking brake function is overridden when the video source is set to CAMERA.
• When the parking brake inhibit is active, the front monitor displays “Parking Is On”, preventing the driver from watching
content while driving. Rear video screens are not affected.
68
Subject to technical changes
To Next Page
Loading...
Need help?
General
