6
OPERATION
BASIC OPERATION
Turn On/Off and Mute Function
Press /MUTE button to turn on the unit. When system is on, press this button to
turn mute on/off. Press and hold /MUTE to power the unit off.
Audio and Setting Menu Adjustment
• Repeatedly press SEL button for the audio menu:
BAS(Bass)-TRE(Treble)-BAL(Balance)- FAD(Fader)-EQ-LOUD(Loudness)
• Press and hold SEL button for the setting menu:
AF-TA-PTY-REG-BEEP-CLOCK-P_VOL-SWC-DX-STEREO
In each menu item, rotate the VOL knob to adjust and set.
Display the Clock or Information
Press DISP button to show the clock or information.
Clock Setting
Press and hold DISP button for 2 seconds. “HH” will flash. Rotate VOL knob to change
the hour. After that press SEL button. “MM” will flash. Rotate VOL knob to change the
minutes. Then press SEL button once again to confirm changes.
EQ and Loud Function
Press EQ button to select preset mode˖FLAT-CLASS-POP-ROCK-EQ OFF.
Press and hold EQ button for LOUD on/off function.
SWC (Steering Wheel Control) Function
In SWC mode of the setting menu, rotate VOL knob to select first desired function (eg.
BAND). Then press and hold the corresponding button (BAND) on the steering wheel
for 1 second. When LCD shows OK, the pairing is successful. Repeat steps above to
program other buttons.
Resetting the Unit
In AUX mode, press and hold "2" button for 5 seconds for reset function.
A reset would be required due to the following:
a) Some buttons do not operate.
b) Error symbol shown on the display.
Note: If the RESET function is activated, all memory (settings & station presets) will
be cleared.
Auxiliary Input
Press SRC button to switch to AUX mode when connecting an external audio source.
To Next Page
Loading...