Audison HV Sedici THK User Manual

Power measures taken according to audison standard 1998 edition.
-12 VDC and 13.8 VDC.
- 1 KHz or crossover cut-off frequency.
- 0.3% THD nominal power; 1% THD continuous power.
- Tolerance: +10%; -5%.
- Continuous power given by RMS Voltage measured on resistive load.
- The nominal power of the amplifier upon a battery voltage of 12 Volts with a 4 Ohms
load and with all channels in function.
PRINTED IN ITALY - Code 10124600
Strada Regina Km 3,5 • I 62018 Potenza Picena (MC) • Tel.0733/870.870 • Fax 0733/870.880 • http://www.audison.com
in out in out
Mute Remote Power
mono
Speaker L
ABS
Inputs RightLeft
Audison Balanced System
Speaker R
mono
on
peak L
safe
peak R
OWNER'S MANUAL
Car power amplifier

Audison HV Sedici THK Specifications

General

Brand	Audison
Model	HV Sedici THK
Category	Amplifier
Language	English

Summary

Introduction and Regulations

Preamplifier

Independent unit regulating general sensitivity, with exclusion possibility.

Final Power Stage

Drives final stages directly, offering voltage driving and thermal stability control.

Proceed as Follows

Steps for setting amplifier sensitivity and volume for optimal performance.

Protections

Electronic safeguards against shorts, overheating, reverse polarity, and loads.

Connection Guide

Outputs Connection

Connecting speakers to L-R terminals and mono configuration.

Power Supply Connection

Connecting positive and negative terminals to the battery.

Turn On Control

Connecting the REMOTE IN input to the radio-cassette player.

Muting Control

MUTE IN input silences amplifier when receiving positive voltage.

Power Supply System

Switching Type Power Supply

PWM controlled push-pull double power supply for stable voltage.

Secondary Voltages

Provides voltages for power stage, preamplifier, and driver circuits.

Primary Protection

Interdicts functioning in case of overloading to avoid circuit damages.

Technical Features and Installation

Technical Features Summary

Key specifications including power, distortion, bandwidth, and sensitivity.

Precautions

Guidelines for proper installation and operation environment.

Installation Guidelines

Advice on mounting, using self-threading screws, and cable connections.

Input Connections

Connecting L-R inputs, balanced/unbalanced, and using ABS connectors.

External Preamplifier Connection

Connecting to an external preamplifier by setting PREAMP switch.