AMP HI 12 dB
PRE OUT HI 12 dB
If the Filter control is switched to FULL, the amplifier power output is not filtered. If HI is
selected, a 12 dB/Oct hi-pass filter is applied. When LO mode is selected, you can choose
whether to cut the lo-pass signal at 12 dB/Oct. or at 24 dB/Oct. These settings are also for
the PRE OUT output, which can be adjusted independently from the amplified section. If you
configure the AMP and PRE OUT sections in the same way, either HI or LO, the same cut-off
frequency will be applied to both, since it is handled by the same filter.
Config. 4, 5, 6
Config. 2, 5, 8
To Next Page
Loading...
