Audison LRx 2.9 - Diagnostic LED Description

OK!
Amp
ON
Logo
OFF
=+
KO!
STOP LISTENING
CHECK SPEAKER CABLES!
Auto Reset
C: Contact with ground
=
STOP LISTENING
CHECK SPEAKER CABLES!
Turn Off Amp to reset
C: Uncertain or rare
contact with ground
=
Flashing
KO!
Amp
OFF
Logo
ON
=+
OK!
Amp
ON
Logo
ON
=+
5857
The Universal Sound
Owner’s manual
LRx 2.4
LRx 2.9
20 Hz200 2K 20K
50÷500
MONO 24 dB/Oct.
20 Hz200 2K 20K
500÷5k
MONO 24 dB/Oct.
AMP LO 24 dB
PRE OUT LO 24 dB
If you connect the stereo inputs and set the filter section to 24 dB (L+R), there will be a
mono signal on both speaker power outputs terminals, the sum of the L + R signal inputs.
We recommend the combined load connected to these terminals not to be lower than
4 Ohms. A mono signal, the sum of L + R signal inputs, will be directed to the PRE OUT
and BYPASS outputs. Signals from left and right connectors will be the same.
Config. 7, 8, 9
Config. 3, 6, 9
Diagnostic LED description