IN L/R Ch
CENTER IN
SUB IN
PRE OUT
Bypass
Full Full Full
Full Full
Full Full
Full
L/R Ch
Config.
1
2
3
4
CENTER SUB Ch
L/R IN L/R Ch
CENTER IN CENTER
SUB IN SUB Ch
PRE OUT L/R IN
SUB
CENTER
R
L
PRE OUT: 5 V RMS
POWER OUT: MAX
4 Ω
PRE OUT: 5 V RMS
ALERT:
Distortion
4 Ω
B
SUB FILTER
CENTER FILTER
B FILTER
A FILTER
A IN L&R
B IN L&R
CENTER IN
SUB IN
SUB
R
L
A
CENTER
R
L
Hi-pass
Hi-pass Hi-pass
Hi-pass
L/R
FILTER
CENTER
FILTER
SUB
FILTER
56 57
The Universal Sound
LRx 3.1MT
LRx 5.1MT
Owner’s manual
I
LRx 3.1MT functions
I
Out Mode
I
LRx 3.1MT control panel
LRx 3.1MT outputs are totally independent and
drive each its specific terminal. To output the
amplified signal you must use the corresponding
input.
I
Filters configuration
I
Inputs / Outputs configuration
To set the control panel switches, please refer to the following pages.
I
LRx 5.1MT functions
I
LRx 5.1MT control panel
I
Out Mode
I
Level 0.3÷5 V (LRx 3.1MT and LRx 5.1MT)
Adjust the input sensitivity control, tuning the amplifier input
section according to the signal which comes from the source;
this exploits the amplifier maximum power without distortion.
I
LRx 3.1MT configuration
To Next Page
Loading...
Need help?
General
