-6- -7-
English
9. LED light
When switched ON and in USB/SD/FM/AUX/clock mode, the
white light will stay lit. When entering Bluetooth and in
pairing mode, the light will flash about twice a second, flash
rapidly then go out when paired successfully but not playing,
and flash every 2 seconds when playing.
The power icon will show for 5 seconds when switching to
different mode, then it will not show until the power is low.
10. Clock Setup
10.1 Date time setting
7. Audio-In Mode
Connect the device to an external multimedia device through
the AUX port by using the supplied accessory cable. Press the
M button to change the mode until the display shows "AUX".
The device will play audio from multimedia devices with a
3.5mm jack connection such as a PC, mobile phone, MP3 and
MP4 players etc.
Note: In the AUX mode, the AUX icon will show above the time.
8. FM Radio Mode
When the SE20 is turned on it will start in FM radio mode
automatically if there is no USB or SD card inserted.
To scan and save all available FM radio channels automatically,
press the button. After searching, you can select the
saved channels by pressing the buttons. Up to
12 channels can be stored and will show on the display as P01,
P02 etc.
To scan and search for the next higher or lower FM radio
channel, press and hold either the button.
Note: In FM radio mode, the FM icon and frequency will be
shown on the display.
“ ”
“ ” and “ ”
“ ” or “ ”
Press the M button to switch to clock mode, then press the
button to select Year/Month/Day/Hour/Minute in
turn. Adjust the digits by pressing , press and
hold for continuous adjusting.
Press the button to finish the setting. Press V- to switch
between 12 and 24 hour mode.
In clock mode, the year, month, day, hour and minute will be
shown and the display backlight will be dimmer.
10.2 Alarm Settings
In clock mode, press and hold the M button to set or cancel the
alarm function. When the alarm is set, the alarm clock symbol
will be displayed. The SE20 must be switched on and in clock
mode for the alarm to work.
Press and hold the button again to enter alarm setting
mode. Set up the hours by pressing the buttons,
“ ”
“ ” or “ ”
“ ”
“ ”
“ ” or “ ”
To Next Page
Loading...