English
-8- -9-
press and hold for continuous adjusting, then press to set
up minutes in the same way. Press the button again
to finish the setting.
The SE20 includes a snooze function. When alarm rings, press
the , V–, / or V+ buttons to snooze, or
press the M button to cancel the alarm. In snooze mode a "Zz"
icon is shown next to the alarm clock icon. To cancel further
snooze alarms press the button when the alarm is not
sounding, and the "Zz" icon will disappear.
If not cancelled or snoozed, the alarm will sound for 1 minute.
Snooze sounds every 5 minutes, and repeats three times.
10.3. SD card / USB / FM radio alarm function
In clock mode, and with the alarm function active so that the
alarm clock icon is showing, press the V+ button so that the
radio antenna icon shows in the display. The SE20 must be
switched on and in clock mode for the alarm to work.
When the alarm time is reached, the SE20 will play the music
from the USB or SD card if inserted, or will play the FM radio
station if no USB or SD card is present. The alarm sound will
not be activated at the same time.
When an SD card, USB or radio is used for the alarm, the music
will continue to play and not stop after 1 minute.
The SE20 will remember the last track played or radio station
listened to, and use this for the alarm sound if the alarm is set
to use the SD card, USB or FM radio.
“ ”
“ ”
“ ” “ ”
“ ”
11. Specifications
LCD Display
Bluetooth Specification
Speakers
USB and SD card port
Frequency Response
File format
Separation
Battery
S/N
Working Time
FM Radio Frequency
Clock Standby Time
Charging Time
Dimensions
Weight
150 x 125 x85mm
87.5 – 108.0MHz
About 2 days
3 hours
70dB
About 7 hours
40dB(1KHz)
Rechargeable Li-ion 3.7v 800mAh
80Hz – 18KHz
mp3
2 x 3Watts
Supports up to 16GB card or USB in
FAT format
Bluetooth V3.0 + EDR
1.8 inch
320g
Charging voltage
DC 5V
To Next Page
Loading...