! !
Warranty claims require proper and profes-
sional assembly, installation and maintenance
in accordance with national regulations and
manufacturer‘s instructions of the drives.
The safety instructions in the supplied pro-
duct documentation are to be observed.
Strictly observe the information given in this
and in the instructions for installation of
the drives when parameterize the A
UMÜLLER-
drives with UniPC.
Details can be found on our website
www.aumueller-gmbh.de
Keep this instruction over the lifetime of the
product.
UniPC (Drive Parameterisation)
Assembly and Commissioning Instructions
UniPC (Drive Parameterisation)
UniPC (Drive Parameterisation):
• UniPC is a parameter assigment software A
UMÜLLER
drives - with the necessary hardware (ParInt). With
this program, a variety of A
UMÜLLER productes can be
con gured.
• For each product, a separate „plugin“ is available.
• Each plugin con gures and controls other drives.
• Con gurable drives: S12, S12 V.2, S3
Part.-No.: 524178
Application: Hard- and software for the con guration of drives
produced by Aumüller A
UMÜLLER AUMATIC GMBH.
Rated voltage: 24 V DC +/-20 %
Con gurable drives: 24 V DC in version S12, S12 V.2, S3
230 V AC in version S12, S12 V.2
Connections: 3x Pluggable screw terminals 1,0 mm²
1x USB Port
Package contents: 1x Software UniPC (Download link)
http://www.aumueller-gmbh.de/Downloads
1x Interface “ParInt”
1x USB cable
1x Connection cable
Feature / Equipment: Power supply 24 V DC not included!
NOTE
Power supply 24 V DC not included!
The power supply 24 V DC of a
control unit or test equipment (Part.-
No.: 533981) can be used!
To Next Page
Need help?
General