auna Connect System S - Initial Set-Up

48
EN
INITIAL SET-UP
When you rst connect the unit to the mains socket, the display will show
the welcome screen then with the privacy policy page come up. Please visit
the website mentioned in the page for the details of the privacy policy.
Press TUNING/ENTER dial on unit or ENTER button on remote control to
accept for next step.
1. To launch the initial Setup wizard, turn the TUNING/ENTER dial on the
unit or 7 / 8 buttons on remote control to select [YES], then press the
TUNING/ENTER dial on the unit or ENTER button on the remote control
to conrm.
2. In the next step you can select the time format. Select the desired setting
[12] or [24] and press the TUNING/ENTER dial on the unit or ENTER
button on the remote control to move on to the next step.
3. Here it is possible to select which source (DAB/FM/Network/No update)
the unit uses to obtain and update the time and date. If "Update from
Network" selected, proceed to the next step to select time zone to
ensure that the time is displayed correctly. And then select the "Daylight
savings" is [ON] or [OFF].
4. In the next step you can specify whether the product should remain
connected to the Internet when on standby. Turn the TUNING/ENTER
dial on the unit or press 7 / 8 buttons on the remote to select [YES],
then press the TUNING/ENTER dial on the unit or press ENTER button on
the remote to conrm.
5. Your radio will now scan for your wireless network, this may take a few
seconds then a list of all the wireless networks will appear on the screen.
Select the WLAN network you know and whether to use WPS (Push
Button/ Pin) or Skip WPS to enter the password using the displayed
keyboard.
6. While you press "Skip WPS", the virtual keyboard is shown on the
display, you can turn the TUNING/ENTER dial on the unit or press PLAY/
PAUSE or 7/8 buttons on the remote control to move the highlight.
PressTUNING/ENTER dial on unit or ENTER button on remote to select
the key.
7. After enter the password, select [OK] and then press TUNING/ENTER
dial on unit or ENTER button on remote to conrm. If the password
entered is correct, a connection to the network is now established. Press
TUNING/ENTER dial on unit or ENTER button on remote to exit.
8. Settings can be changed at any time by pressing the MENU button to
display the menu. Press  /to select system settings and then press
the ENTER button to conrm. And press  / buttons to select Setup
wizard and then press the ENTER button to launch Setup wizard again.
This instruction manual explains the basic instruction for operating this
unit. Unless otherwise stated, all operations described are based on remote
control use.