auna Connect System S - DAB Operation

57
EN
DAB OPERATION
Press the MODE button repeatedly to select “DAB radio”. The unit will enter
DAB mode and perform the auto scan function. During the scan the display
will show “Scanning… ” together with a slide bar that indicates the progress
of the scan and the amount of stations that have been found so far. (F.7)
Once the scan has nished, the unit will select the rst alpha numerically
found station. To explore the found stations, press the  / buttons to
select and press ENTER to conrm.
Station List
1. During DAB mode, press the MENU button to access DAB menu.
2. Press the  / buttons to select “Station List” and then press the
ENTER button to conrm.
3. A list of DAB+ stations will show on the display.
Auto Scan
1. Press MENU, and then press the  / buttons to select Scan. Press the
ENTER button to conrm.
2. The display will show “Scanning…” and a progress slide bar.
3. All the stations that have been found will be stored automatically. To
explore and listen to the found stations, press the  / buttons to
select and the press the ENTER button to conrm.
Manual Tuning
As well as the auto tune function, you can manually tune the receiver. This
can help you when aligning your aerial or when adding stations that were
missed while auto tuning.
1. Press MENU on the remote control to display the menu.
2. Press the  / buttons to select “Manual tune”, and press the ENTER
button to conrm.
3. The display will show the multiplex 5A to 13F.
4. Press the  / buttons to select the channel, and press the ENTER
button to conrm.
5. To listen to any stations found, return to the now playing screen and
press the  /buttons to select the required station from the station list
and press ENTER button to conrm.