auna Connect System S - Page 52

52
EN
Software update
1. During System settings mode, press the / buttons to select Software
update and then press the ENTER button to conrm.
2. Press the / buttons to select Auto-check setting or Check now, and
then press the ENTER button toconrm.
Before downloading software, ensure that the radio is plugged into a stable
mains power connection. Interrupting the mains supply during software
download can lead to functional disturbances and/or damage to the unit!
Setup wizard
The setup wizard is available in the system settings section; you can run
through this to congure settings for date/time and network. Once this has
nished, your radio is ready to use.
Info
1. During System settings mode, press the / buttons to select Info and
then press the ENTER button toconrm.
2. The software version, Radio ID and Friendly Name will show on the
display.
Info
1. During System settings mode, Press / buttons to select Info and
then press ENTER button to conrm.
2. The software version, Radio ID and Friendly name will show on the
display.
Backlight
1. During System settings mode, press the / buttons to select Backlight
and then press the ENTER button to conrm.
2. For the other settings under Backlight, press the / buttons to select the
following options and then press the ENTER button to conrm.
Operation Mode
High / Medium/ Low
Standby Mode
Timeout o/ 10 sec / 30 sec / 60 sec
Standby Level: High /Medium/Low/O