auna Worldwide - Network Configuration; Wireless Network Setup; System Settings and Setup Wizard

24
www.auna.de
Wireless network:
• Check rst of all whether the control lamps (LINK/ACT) of your WLAN connection or your router light up.
• Proceed for the operation as described in the below “GETTING STARTED”. It is highly recommended to
run through the setup wizard in the system settings section.
Note: Information on the WLAN/WiFi network connection can be obtained from the user manual of
the router manufacturer. Walls or other obstacles may inuence the WiFi range. Try to nd the best
location to avoid interruption and interference while operating.
Getting started
When you rst connect the unit to the mains socket, the unit will be in Standby mode after starting. Press
the power button once to switch on the radio, the display will show the Setup wizard, rotate the SELECT
control followed by pressing on it to conrm the setting step by step.
Main menu
The following modes can be selected in the main menu: Internet radio, Music player, DAB radio, FM radio,
AUX in, Sleep, Alarms, System settings. To select your desired function, rotate the SELECT control followed
by pressing on it to conrm.
System settings
Set up wizard
The setup wizard is available in the system settings section, you can run through this to congure settings
for date/time and network, once this has nished, your radio is ready to use. Note: No need to run through
the setup wizard if a wired network is used.
• 12/24 hour display: To select your preference between 12 or 24 hour clock display format - rotate the
SELECT control followed by pressing on it to conrm.
• Time/Date: The time and date can be manually set or automatically via the network, DAB or FM.
Auto update: The auto update works with data sent over DAB, FM or the Internet. The clock is only
updated when in a corresponding mode, so it is recommended to select a mode that you use regularly.
• Select auto update from DAB, FM or Network.
• Select the appropriate time zone if the auto update is done by the Internet.
• If your country uses daylight saving, the automatically update time may be wrong by one hour. Set
th daylight savings to ON when daylight savings are in eect.
Manual set:
• If “No update” is selected, the wizard will prompt you to set the time and date manually. The date
and time are displayed in dd-mm-yyyy and hh:mm AM/PM format. The value to be set will ash,
rotate the SELECT control to adjust the value followed by pressing on it to go for the next setting,