AURATON Libra can work in two modes:
Heating mode (preset) – set it if you want AURATON Libra to
cooperate with heating devices.
Air-conditioning mode – set it if you want AURATON Libra to
cooperate with air-conditioning devices.
Turn the knob to the left or right to set the required mode. Confirm your choice by
pressing the ( button. AURATON Libra will proceed to change the next parameter.
Changes in hysteresis
Hysteresis is supposed to prevent too
frequent activation of the actuator due
to small temperature fluctuations.
For example, in the case of HI 2
hysteresis, when the temperature is set
to 20°C, the boiler will be switched on
at 19.8°C, and switched off at 20.2°C.
In the case of HI 4 hysteresis, when
the temperature is set to 20°C, the
boiler will be switched on at 19.6°C,
and switched off at 20.4°C.
To Next Page
Loading...
