The hysteresis change mode is signaled by a flashing HI. Turn the knob to the left or
right to set the desired hysteresis.
HI 2 – ±0,2 °C (preset),
HI 4 – ±0,4 °C,
HI P – PWM operating mode (see chapter “PWM operating mode”).
Confirm your choice by pressing the ( button. AURATON Libra will proceed to
change the next parameter.
Changes in the delay
The delay prevents too frequent activation of the actuator, e.g. due to temporary drafts
(caused by opening the window, etc.).
The delay change mode is signaled by
a flashing 90:SE. By turning the knob
left or right, we set the delay.
90:SE – delay of 90 s (preset),
0:SE – no delay
Confirm your choice by pressing the
( button. AURATON Libra will
proceed to change the next parameter.
To Next Page
Loading...
