This function is used to correct the clock indications in case of any deviations. If the
clock is working incorrectly within a week, the extent of incorrect clock indications
should be determined. This value should be entered in AURATON Libra in the form of
seconds.
Example 1:
After a week of operation, AURATON Libra shows time accelerated by 1 minute and 20
seconds (60 + 20 = 80). In this case you should slow down the clock by setting C -80.
Example 2:
After a week of operation, the clock in AURATON Libra is 2 minutes slow (2 x 60 =
120). In this case you should speed up the clock by setting C 120.
IMPORTANT:
The number of seconds should be determined after one week of operation of
AURATON Libra for the clock calibration function to work correctly (7 days =
the number of seconds to be added or subtracted, maximum 294 seconds).
IMPORTANT:
If no button is pressed for 10 seconds while changing the configuration
settings, AURATON Libra will return to the normal operating mode.
To Next Page
Loading...
