USB2
Please set the mode when used with PC with the USB2.0 ports
USB3
Please set the mode when used with the PC with the USB2.0.
When FLOW is connected to PC with USB 3.0 port and the mode is set to USB3, the copy speed and charge
speed becomes faster than USB2.0 mode. You need a USB3.0 cable to fully utilize the speed of USB3.0.
Mac
When FLOW is connected to the Mac, please set the host mode to Mac. The charging speed will be faster than
in other modes.
iOS
When FLOW is connected to iPhone/iPad, please set the host mode to iOS. If not, iPhone/iPad will display a
warning message indicating too much current and FLOW will be shutdown automatically.
anDR/Android
When FLOW is connected to Android devices, please set the FLOW's host mode to anDR.
* Not all Android devices support USB Audio. FLOW will work only with the Android devices which support
Audio output through the USB port.
CHG
Next click shows the Charging mode
CHG+ : Always charge
CHG- : Always no charge
CHGA- : Charge Automatic. (Charge only when not playing music)
mSATA Setting
mST : Next click shows the status of mSATA drive installed.
mST- : mSATA not installed
mST+ : mSATA installed
* You can set mSATA to not being used even though mSATA drive is installed. To do this, you can change to
MST - by using the direction button.
OPT
To decide the input priority when both optical cable and USB cable are attached.
OPT+ : Set input to optical
OPT- : Set input to USB
DIM
Shows the brightness setting of LCD back light.
* You can change the brightness by pressing directional button.
There are four steps from DIM0 to DIM3.
V027
Shows the version number of the current firmware.
*This is for internal use only.
Advanced Menu - Click & Hold (long-press)
pcm
PCM filter options for use when playing PCM files.
pcm0 : Fast roll-off PCM Filter (default setting).
pcm1 : Minimum phase PCM Filter (virtually eliminates ringing from signals).
pcm2 : The Slow roll-off PCM Filter is an in-band filter and the output signal will be slightly attenuated.
To Next Page
Loading...