AUSA C300H - Page 120

C300H / C300HI / C300H x4 / C300HI x4
C350H / C350HI / C350H x4 / C350HI x4
118
Rotating beacon bulb: replacing (fig. 1, 2)
- Turn the amber cover (a) of the rotary beacon to the left and remove.
- Unhook the plate (b) holding the bulb by pressing it inwards and to the left at the
same time.
- Replace the bulb with a new bulb of the same type and power.
CAUTION
Do not touch the surface of the glass of the bulb. If it is dirty wipe gently using
a clean dry cloth.
- Fasten the plate holding the bulb by pressing it inwards and to the right at the
same time.
 Electrical system
Steering column fuses: checking (fig. 3)
- Switch off the ignition.
- Remove the protective cover from the fuses by pulling it outwards.
- The burnt fuse can be recognised as the metal strip which is visible in the centre
of each fuse will have melted (viewing window).
- Remove the burnt fuse and replace with a new fuse of the same type.
CAUTION
Do not use fuses of a higher value, this could cause major damage.
Battery fuses: checking (fig. 4)
- Switch off the ignition.
- Remove the protective cover from the fuses (c).
- The burnt fuse can be recognised as the metal strip which is visible in the centre
of each fuse will have melted (viewing window).
- Remove the burnt fuse and replace with a new fuse of the same type.
CAUTION
Do not use fuses of a higher value, this could cause major damage.
(fig. 4) (fig. 3) (fig. 2) (fig. 1)
a
b
c
Periodic
Maintenance
Operations