EasyManuals Logo

Austro Engine AE50R User Manual

Default Icon
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
AE50R, AE50RA
AE50RAB
Engine Manual
Doc. No. E1.01.01-E Rev. 6 10-March-2011 Page 9-2
9.2 Engine Start down to Approximately -10 °C
The engine will start equally well with either permitted fuels.
9.3 Ground Tests
(See 15.0)
9.3.1 Full Power Check
Set WOT and note rpm achieved in relation to the minimum acceptable value as defined in the
aircraft operating manual. Check that all instrumentation is functioning and that all parameters
are within limits. Check that single ignition drops are less than 300 RPM at 6200 RPM.
9.3.2 Idle Check
Fully close the throttle and note rpm; it should be 2300 RPM ± 100 RPM. Adjustment, if
required, is by the throttle stop screw on the throttle body. For method, and precautions, see
the aircraft manufacturer’s manual.
9.3.3 Stopping the Engine
It is usual to idle the engine for 2 to 3 minutes before stopping (to dissipate internal heat prior
to shut down) [see aircraft manufacturers operating manual].
Switching off either the ECU power, or ignition switches, or the fuel pumps will stop the
engine. The latter gives a short run down and dissipates pressure in the fuel lines.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Austro Engine AE50R and is the answer not in the manual?

Austro Engine AE50R Specifications

General IconGeneral
BrandAustro Engine
ModelAE50R
CategoryEngine
LanguageEnglish

Related product manuals