Dynamic Series
Part A: Description, warnings and instructions
Working
A - 18
6 Working
6.1 BATTERY
The Dynamic series' transmitting units can only be powered through Autec re-
chargeable batteries.
See the battery charger manual enclosed in the packaging with the battery charg-
er for any warnings and instructions regarding the batteries.
Batteries shall be inserted in their housing in the transmitting unit, with the tech-
nical data plate facing down and their contacts towards the contacts on the trans-
mitting unit.
To insert a battery, proceed as follows:
1. push the battery towards the contacts on the transmitting unit
2. push the battery downwards.
To remove a battery, proceed as follows:
3. push the battery towards the contacts on the transmitting unit
4. lift the battery.
6.2 S-KEY
In the transmitting unit, the radio remote control address
is stored in the S-KEY. For this reason, the radio remote
control cannot work without this key.
The S-KEY can only be used in the transmitting unit
of the radio remote control where it belongs (main
transmitting unit).
2
1
4
3
To Next Page
Loading...
Need help?
General
