10.1 Motor Starting
Press in or out on both command sticks for about 2 seconds to start
the motors.
10.2 Take off
Slowly push up the left stick to take off the aircraft to 2.5m height.
10.3 Landing
Slowly push down the left stick until the aircraft lands. Hold the left
stick until the motor stops.
10. Takeoff / Landing (Mode 2)
or
9
Note
Mode 2 is the default control mode of the Smart Controller. The
left stick controls the altitude and heading of the aircraft, while
the right stick controls the forward, backward and sideward
movements.
Before takeoff, place the aircraft on a flat and level surface and
face the rear side of the aircraft towards you.
Please make sure that the controller is successfully paired with
the aircraft.
To Next Page
Loading...