11
12. Firmware Update
To ensure users have a premium operating experience, Autel
Robotics will update firmware when necessary. You can refer to the
following steps to upgrade.
1. Power on the controller and make sure it is connected to the
internet.
2. Run Autel Explorer App. A pop-up will appear when new firmware is
available. Tap the notification to enter the update interface.
3. Update will start automatically after downloading the latest
firmware. Please restart the controller when the update is complete.
13. Specifications
Image Transmission
902-928MHz（FCC）
2.400-2.4835GHz
5.725-5.850GHz（Non-Japan）
5.650-5.755GHz（Japan Only）
*Operating Frequency
Max Signal Transmission
Distance(No interference,
No obstacles)
Note
Before updating, please make sure the controller battery is
above 50%.
If the network is disconnected during the firmware downloading,
the upgrade will fail.
The update takes approximately 15 minutes. Make. Please wait
patiently.
FCC：15km CE：8km
To Next Page
Loading...