10
© 2012 Directed. All rights reserved.
Remote Start Faults
For user safety, the system must be properly configured or remote start
will not activate. A Remote Start Fault may be caused by any of several
configuration issues. Refer to the table below for the command type
and parking light flashes that will identify the configuration issue and
solution.
Flashes * Possible Fault Solution
5 Brake on Release foot brake
6 Hood open Close hood
7 After performing Remote Start
command - MTS not enabled
Enable MTS mode
8 Toggle Switch off Turn switch on
Rapid Resume Logic
This Directed system stores its current state to non-volatile memory. If
power is lost and then reconnected the system recalls the stored state
from memory. This means if the unit is in Locked Mode and the battery
is dis con nect ed for any reason, such as when servicing the vehicle,
when the battery is re con nect ed the unit maintains Locked Mode. This
applies to all states of the system.
Control Center
The control center is mounted high in the vehicle usually on the wind-
shield in a location close to the rear view mirror. It consists of a an-
tenna/receiver for communicating between the control module and
remote controls, and a control button with status LED for programming
system features.
To Next Page
Loading...
Need help?
General
