31
© 2012 Directed. All rights reserved.
Feature Details
31
Full Silent Arm Protection
Sensor Warn-away, Sensor Full Trigger and Point of Entry activations
will only send messages to the remote, with parking light flash and
siren outputs defeated.
Sensor Warn-away Messages
When the remote receives a Sensor Warn-away message it emits
10 beeps (if on) and displays a sensor zone specific
SENSOR WARN
text for 30 seconds. Warn-away messages cannot be reviewed or
displayed in reports.
Full Trigger Messages
A Full Trigger message generates a Full Trigger output of siren tones
and zone specific
TRIGGER
text followed by an alert that consists of
1 long beep per minute for 10 minutes.
To stop the output and alert, press a command button to perform a
command, or Press the
button.
Emergency Override
The following procedure disarms the system when a programmed re-
mote is not available. Number of presses__________
1. Turn the ignition On.
2. Press the control button on the Control Center the correct
number of times (the default is 1 press).
3. After a few seconds the siren output ceases and the system
is disarmed.
Note
As a precaution, if programmed for Passive Arming or Auto
re-arming the system should be placed into Valet Mode until
a remote is available .
To Next Page
Loading...
Need help?
General
