11
© 2005 directed electronics—all rights reserved
remote start unit has not been properly installed. The remote
start module must be removed or the installer must properly
reinstall the remote start system so that the vehicle does not
start in gear. All installations must be performed by an autho-
rized Directed dealer.
OOPPEERRAATTIIOONN OOFF TTHHEE RREEMMOOTTEE
SSTTAARRTT MMOODDUULLEE IIFF TTHHEE VVEEHHIICCLLEE SSTTAARRTTSS IINN GGEEAARR
IISS CCOONNTTRRAARRYY TTOO IITTSS IINNTTEENNDDEEDD MMOOD
DEE OOFF OOPPEERR--
AATTIIOONN.. OOPPEERRAATTIINNGG TTHHEE RREEMMOOTTEE SSTTAARRTT SSYYSSTTEEMM
UUNNDDEERR TTHHEESSEE CCOONNDDIITTIIOONNSS MMAAYY RREESSUULLTT IINN
PPRROOPPEERRTTYY DDA
AMMAAGGEE OORR PPEERRSSOONNAALL IINNJJUURRYY.. YYOOUU
MMUUSSTT IIMMMMEEDDIIAATTEELLYY CCEEAASSEE TTHHEE UUSSEE OOFF TTHHEE
UUNNIITT AANNDD SSEEEEKK TTHHEE AASSSSIISSTTAANNCCEE OOFF A
ANN AAUUTTHHOO--
RRIIZZEEDD DDIIRREECCTTEEDD DDEEAALLEERR TTOO RREEPPAAIIRR OORR
DDIISSCCOONNNNEECCTT TTHHEE IINNSSTTAALLLLEEDD RREEMMOOTTEE SSTTAARRTT
MMOODDUULLEE.. DDIIRREECCTTEEDD WWI
ILLLL NNOOTT BBEE HHEELLDD
RREESSPPOONNSSIIBBLLEE OORR PPAAYY FFOORR IINNSSTTAALLLLAATTIIOONN OORR
RREEIINNSSTTAALLLLAATTIIOONN CCOOSSTTSS..
active arming
You can arm the system by pressing of your transmitter for
one second. When the system arms, you will hear a short siren
sound, or chirp, and see the parking lights flash once. If the power
door locks are controlled by the system, the doors will also lock.
While the system is armed, the status LED will flash approximately
once per second, indicating that the system is actively protecting
your vehicle. If you hear a second chirp after arming and note that
the status LED is flashing in groups, see the Diagnostics Section of
this guide. This extra chirp is called Bypass Notification.
➜
To Next Page
Loading...
Need help?
General
