Automated Logic ZS Plus User Manual

ZS Plus Sensor
A ZS Plus lets you:
• Make the zone warmer or cooler
• Override the schedule to put the zone in an occupied state
• Force the zone to an unoccupied state
• See that the zone is in an occupied state when the green LED is
lit
To make the zone warmer or cooler
Slide the sensor's potentiometer up to make the zone warmer or down to make it cooler. The control
program determines how much you can adjust the setpoint.
To override the schedule
Timed override to an occupied state
Press the button one time to override the schedule and put the zone in an occupied state for a
length of time specified in the control program's
Maximum Duration
field.
Press the button again to cancel the override and return control to the schedule.
Force to an unoccupied state
If allowed by the control program, press and hold the button for 3 seconds to force the zone to an
unoccupied state.
Press the
button again to cancel the force to unoccupied and return control to the schedule.
ZS Sensors ALC Proprietary and Confidential © 2015 Automated Logic Corporation
Rev. 4/27/2015 All rights reserved
2

Automated Logic ZS Plus Specifications

General

Brand	Automated Logic
Model	ZS Plus
Category	Accessories
Language	English