Chapter 4 - Installation and Wiring
4-3
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
Introduction
The installation and wiring of the C-more® touch panels requires selecting an appropriate
location for the touch panel, laying out the cutout dimensions on the surface of the control
cabinet that the panel will be mounted through, securing the touch panel with the provided
mounting clips, tightening the screws to the appropriate torque rating to assure the gasket is
sealing correctly, and finally connecting the appropriate power source to the touch panel.
NOTE: Each C-more touch panel is provided with a cutout template to make marking the proper cutout size on the
surface of the control cabinet that the panel will be mounted through a simple task.
This chapter covers the proper mounting of the touch panel and connecting power. Once
power is applied to the touch panel, the user will want to read Chapter 5 on the System Setup
Screens in order to set the internal time and date for the panel, become familiar with the
touch panel test features, and check memory options.
Mounting Clips - EA9-BRK
To Next Page
Loading...