AutomationDirect C-more EA9-T6CL-R - EA9-T8 CL and EA9-T10 WCL Cutout Dimensions

Chapter 4 - Installation and Wiring
4-5
®
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
B
C
D
EA9-USER-M Hardware User Manual, 1st Ed. Rev. K
EA9-T8CL and EA9-T10WCL Cutout Dimensions
The C-more EA9-T8CL and EA9-T10WCL touch panels will mount into the same cutout
and are mounted into the cutout through the control cabinet and secured with four (4)
mounting clips. The mounting clips are provided with the touch panel. The mounting clips
will insert into a series of slots around the rear perimeter of the touch panel. Each clip has
a tab that will mate to a slot. The screw of each mounting clip needs to be tightened to the
torque rating shown in the table below so that the gasket is compressed to form the proper
seal between the panel and cabinet surface.
Enclosure Mounting Thickness Ranges
and Mounting Clip Screw Torque
Touch
Panel Size
Enclosure
Thickness Range
Mounting Clip
Screw Torque
Material
6”, 7”, 8”,
10” & 12”
0.039 - 0.20 inch
[1 – 5 mm]
63 - 77 oz-in
[0.45 - 0.55 Nm]
Metal
10” Wide,
15”
0.039 - 0.20 inch
[1 – 5 mm]
92 - 106 oz-in
[0.65 - 0.75 Nm]
Metal